Having the right Xuron cutters and using them correctly has helped me considerably. They also have shorter handles for working in confined spaces, with a total length of 15cm versus 20cm of the 2175B, as will often be the case when working with rails that are fixed in place on a layout. These are designed for cutting rails that have been laid, where it’s not possible to get under the rails, using a side-to-side rather than top-to-bottom action as is the case with the 2715B. This takes me nicely to the other version, the Xuron 2175M track cutter. Xuron 2175M used on laid track when you can’t get to the underside of the rails. The best head magnifier for model railways.The best screwdrivers for model railways.Doing so allows clean cuts with no rough ends or burs. Using this technique will give two flat, square ends. Make sure the flat side is facing the section of track that you want to retain. You’ll also see the cutters have a flat face on one side, the rails end facing this surface will be square. To cut the rails, hold them flat and steady and present the cutters to the rail so the cut is from top to bottom, as seen in the photo below, not side to side as I’d done and in so doing damaging the rail profile. For tracks with plastic bases, such as a Kato, I’d recommend using Dremel or razor saw. These cutters work for Hornby and Peco fixed or flexi-track, Brass or Silver/Nickel rails up to code 100. It works for Z, N, TT, and OO gauges and when used correctly, unlikely how I used them, has a shear-cutting action to give square ends to the rails. The Xuron 2175B model is what I use most often, being used for track that has not yet been laid or where you can easily hold it clear of any base material. The Xuron 2175B cutters are used for cutting track when it’s not on the baseboard and where you can get to the rails from the sides. The following explains when to use each – make sure to get the right one. The Xuron 2175B and the 2175M and each is designed to be used in different ways for different applications. Well first things first, there are actually two types of Xuron track cutters. So how do you use them? Two types of Xuron track cutters I’d used them wrongly and the rail ends were rough and misshaped and I couldn’t get rail joiners to slide over them. It was only when I came to slide the rail joiners over the newly cut ends I realised the error of myĪs good as the cutters are they’re only as good as the person using them and being an idiot, well the results spoke for themselves. When I got my first pair of Xuron cutters, I just attacked my rails, cutting them with abandon. Researching and drawing up landscape and track plans, building scenery, and laying track is what gives me the most enjoyment.Īnd as a result, I’m continually cutting, laying, and fixing track.įor much of this track work, my Dremelis the go-to tool but when I want precise, perfect cuts, Xuron track cutters are always within grasping distance. The community for this website isn’t named ModelRailwayBuilders by chance. Instead, it’s creating and building layouts. I can disappear into my loft, shed, or den, depending on which railway I’m working on, and spend hours in my own little world.īut it’s not running trains that give me enjoyment. The thing I turn to when I need to relax. Struggling to get clean, straight ends, for your N, OO, and HO track when cutting it? Here’s how I use the Xuron cutters to get the perfect track every time.

Hacksaw train rails